Evitacol Grey

Cementitious Adhesive for Indoor Use

  • Adhesive for indoor use
  • High porosity tiles
  • Excellent workability

Grey cement-based adhesive, classified as an adhesive for indoor use according to Standard UNE-EN 12004.


Evitacol Grey CE is available in 25 kg paper sacks with moisture-proof plastic lining, dispatched on shrink-wrapped pallets weighing a total of 1280 kg (64 sacks).


Tiling indoor floors and finishes using ceramic tiles of medium/high porosity (> 3%). A double glue technique should be used for tiles larger than 30 cm x 30 cm.

Application Surfaces

Conventional surfaces and cement-based mortar floors and finishes. The application surface must be resistent, perfectly set and free from dust, paint, oil, etc.


Adhesive for Indoor Use






Add water and mix manually or mechanically until you reach a homogeneous paste of a workable consistency.

Leave the paste to stand for 5 minutes and remix before applying.

Spread the paste on the surface in sections of a surface area no larger than 2 m2, combing with a suitable trowel. If double gluing is required, spread the mixture over the back of the tile as well.

Put the ceramic tiles on top of the freshly-laid adhesive, pressing lightly to ensure that the whole tile surface comes into contact with the adhesive, filling any grooves.

Leave a joint of a width of at least 1.5 mm between indoor tiles. Wait 24 hours before grouting wall tiles and 48 hours before grouting floor tiles.

Respect all perimeter and structural joints. Place one partition joint every 50 m2 on indoor floors.

Technical Features

  • Appearance | Grey Powder
  • Grain Size | < 1mm
  • Powder Density | 1,4 Kg/l
  • Mixing Water  | 4-4,4 l/sack
  • Paste Density | 1,65 Kg/l
  • Paste Life | 2h
  • Open Time | 20 minutes
  • Adjustment Time | 15 minutes
  • Adhesive Strenght(normal conditions) | ≥ 0,5 N/mm2
  • Adhesive Strenght after Water Cycle | ≥ 0,5 N/mm2
  • Yield |

    • Single Glue: 3-4 Kg/m2
    • Double Glue: 6-8 Kg/m2
Warnings and Recommendations
  • Do not apply this product when frost is forecasted
  • Do not apply at temperatures below 5°C or above 35°C
  • Do not apply in areas where there is a risk of standing water
  • In extreme weather conditions (wind or high temperatures), the product will dry more quickly than usual. This will result in a shorter open time
  • In high temperatures, windy conditions or if the application surface is very absorbent, it is advisable to moisten the surface and wait for the film of water to disappear before applying the product
  • Check, periodically, that a surface film has not formed on the adhesive paste once it has been spread onto the surface. If a film has formed, remove the product and apply a fresh coat
  • Check that the paste is sticky enough by periodically lifting one of the tiles already in place to ensure that it is well stuck down
  • Use within 1 year of date of packaging. Store the product in its original packaging in a dry, covered place protected from humidity