Evitacol Special Swimming Pools White
High-Performance Cement-Based tile Adhesive C1TE
Highly moisture-resistant adhesive, for laying ceramic tiles of medium/high/low porosity, both indoors and outdoors. High adhesive strength.
Evitacol Special Swimming Pools White C1TE is available in 25 kg paper sacks with moisture-proof plastic lining, dispatched on shrink-wrapped pallets weighing a total of 1.600 kg (64 sacks).
Applications
Tiling indoor floors and finishes and outdoor floors using ceramic tiles of medium/high/low porosity. Suitable for use for laying marble and “gresite” vitreous paste.
A double glue technique should be used for tiles larger than 900 cm² (30 cm x 30 cm). Suitable for use with small format porcelain tiles.
Application Surfaces
Conventional surfaces and cement-based mortar floors and finishes. The application surface must be hard, perfectly set and free from dust, paint, oil, etc.
Instructions
Add water and mix by hand or mechanically until you obtain a smooth paste of a workable consistency.
Leave the paste to stand for 5 minutes and mix again before applying.
Spread the paste on the surface in sections of a surface area no larger than 2 m², combing with a suitable trowel. If double gluing is required, spread the mixture over the back of the tile as well.
Put the ceramic tiles on top of the freshly-laid adhesive, pressing lightly to ensure that the whole tile surface comes into contact with the adhesive, filling any grooves.
Leave a joint of a width of at least 1.5 mm between indoor tiles and at least 5 mm between outdoor tiles. Wait 24 hours before grouting wall tiles and 48 hours before grouting floor tiles.
Respect all perimeter and structural joints. Place one partition joint every 50 m² for indoor floor tiling, and one every 30 m² for outdoor floor tiling.
